![](/portals/0/Cable%20Installation%20Line%20Art%20No%20background.png)
Remove Screw (3) from Cable Adapter (4). Rotate the Cable Adapter 90 degrees and remove from Cable Tower (2).
![](/portals/0/Cable%20assembly%20instruction%201_5%20%281%29.png)
Assemble Cable (6), Cable Adapter (4), and Spring (5) as shown.
![](/portals/0/Cable%20assembly%20instruction%202-disassembled_2%20%281%29.png)
![](/portals/0/Cable%20assembly%20instruction%202-assembled_2%20%281%29.png)
Slide Cable Adapter assembly back onto the shaft, compressing spring slightly to fit into the Cable Tower (2)
![](/portals/0/Cable%20assembly%20instruction%203-disassembled_5%20%281%29.png)
![](/portals/0/Cable%20assembly%20instruction%204_2%20%281%29.png)
Rotate cable adapter assembly 90 degrees and re-install Screw (3). Insert Cable Sleeve (7) end into Cable Tower (2) until fully seated.
![](/portals/0/Cable%20assembly%20instruction%204_2%20%282%29.png)
Use optional noodle to route cable radius, if applicable
![](/portals/0/Cable%20assembly%20instruction%204%20%281%29.png)